510NR Ripping Shell End Mills
In stock
SKU
510NR
M35 Cobalt High Speed Steel Right Hand Cutting Ripping Tooth Form
With keyed bore, front recess and rear driving slot (DIN 138) DIN1880 Type NR
Cutters for rapid metal removal in most ferrous and some non-ferrous materials. Teeth have relieved form for
faster feed rates and heavier cuts. They do, however, leave a rougher surface than Type N Cutters (510N).
510NR cutters are produced as standard only in metric sizes, but can be ordered as specials to suit fractional
arbors.
* Number of teeth (Z) in cutters may not cover all the current stocks, and cutters with small differences in the number of teeth to those
shown above may be supplied.
Shell End Mills with Ripping Tooth Form can be supplied to special order with most of the special features mentioned under the
Standard series No. 510N.
The Ripping Form may also be in flat crested profile(DIN1880 form NF) in which the rounded crest of the form is truncated,
so as to provide a compromise finish which is not as rough as produced by –NR form. A further form, (DIN1800 Form HR) has the
profile set at a finer pitch, which may be specified for cutting very hard stainless, titanium, and similar materials.
Coatings of Titanium Nitride (TiN) or Titanium Aluminium Nitride (TiAlN) are sometimes found useful for prolonging tool life on this
type of cutter. All of the above variants are made to order, the quantity ordered will determine the unit price.